The deicing and snow-melting agent is easy to use. When deicing and snow-melting the airport runway, it can be done with the general spraying equipment of the airport.

Composition: Potassium formate content: 50% Min

Corrosion inhibitor: 2.0% Max

Appearance: Colorless and odorless clear liquid

Density (SG, 25 ℃): 1.350 min

Freezing Point: Below -50 ºC Miscibility with water | completely miscible in water

PH value : 11.0-11.4

Usage and Dosage:

If the thickness of the ice layer or snow layer is greater than 3 mm, it is not suitable to use the deicing fluid directly. In this case, the snow removal and deicing machinery should be used to remove the surface snow before spraying the deicing and snow melting agent; because this product can prevent the ice layer from sticking to the road surface, it is easy to clean by a snowplow or a deicing machine. It can also be sprayed on the eve of bad weather as a preventive antifreeze.

If the thickness of the ice layer or snow layer is less than 3 mm, please refer to the dosage in the following table:

When the thickness of frost and ice is less than 1 mm:

When the amount of snow or ice is 1-3 mm thick:

Because the effect of deicing agents depends on many factors, such as weather conditions (wind, temperature, humidity, rain, snow, frost, freezing rain, etc.), the materials used on the road surface, and spraying equipment. Therefore, the above usage amount is for reference only, and should be increased or decreased according to the specific circumstances in actual use.

Storage and Transportation:

Should be stored in clean and clean polyethylene, fiberglass or stainless steel tanks. Any pollution in storage will adversely affect the deicing and snow melting effect. It can be transported by IBC TANK or stainless steel tanker.